Chapter 9 Maintenance
HES-309M Series User’s Guide
132
9.15 Restore
Use this screen to restore your WiMAX Device settings from a backup file on a
local computer.
Click Maintenance > Backup/Restore > Restore to open this screen as shown
next.
Figure 64 Restore Screen
This screen contains the following fields:
9.15.1 The Restore Configuration Process
When the WiMAX Device restores a configuration file, the device automatically
restarts. This causes a temporary network disconnect.
Note: Do not turn off the device while configuration file upload is in progress.
If the WiMAX Device’s IP address is different in the configuration file you selected,
you may need to change the IP address of your computer to be in the same
subnet as that of the default management IP address (192.168.5.1). See the
Table 54 Restore
LABEL DESCRIPTION
Configuration
File
Click Choose File then browse to the location of a firmware upgrade
file and select it.
Click File Restore to upload the specified configuration to the WiMAX
Device and replace the current settings.
Backup
Configuration
File URL
Enter the URL or IP address of the backup configuration file’s location
on the network.
Click URL Restore to upload the specified configuration to the WiMAX
Device and replace the current settings.
To Next Page
Loading...
