Chapter 7 Network Settings
HES-309M Series User’s Guide
84
7.7 DHCP
Use these settings to configure whether the WiMAX Device functions as a DHCP
server for your local network, or a DHCP relay between the local network and the
service provider. You can also disable the DHCP functions.
Click Network Setting > LAN > DHCP to open this screen as shown next.
Figure 31 DHCP Screen
This screen contains the following fields:
Table 25 DHCP
LABEL DESCRIPTION
DHCP Server
DHCP Mode Select this if you want the WiMAX Device to be the DHCP server on the
LAN. As a DHCP server, the WiMAX Device assigns IP addresses to
DHCP clients on the LAN and provides the subnet mask and DNS server
information.
• None - This disables DHCP mode for the WiMAX Device.
• Server - This sets the WiMAX Device as a DHCP server for the LAN.
• Relay - This sets the WiMAX Device as a DHCP relay for the LAN,
allowing it to pass-through IP addresses assigned to LAN devices
from the ISP servers.
To Next Page
Loading...
