Chapter 6 WiMAX
HES-309M Series User’s Guide
66
6.6 Wide Scan
This screen allows you to discover base stations by entering one or more
frequency ranges and bandwidth on which to scan.
Click WiMAX > Wide Scan to open this screen as shown next.
Figure 19 Wide Scan Screen
This screen contains the following fields:
Table 14 Wide Scan
LABEL DESCRIPTION
Wide Scan Settings
Auto Wide
Scan
Use this to enable (Yes) or disable (No) automatically scanning for
base stations.
Wide Scan Range
Start
Frequency
(KHz)
Enter the start frequency in kilohertz (KHz) for a wide scan range.
End
Frequency
(KHz)
Enter the end frequency in kilohertz (KHz) for a wide scan range.
Step (KHz) Enter the step increment in kilohertz (KHz) that the wide scan jumps
each time it scans between the start and end frequencies.
Bandwidth
(MHz)
Enter the frequency bandwidth to be scanned.
Delete Click this to remove a range of frequencies from the wide scan range
list.
Add Click this to add a range of frequencies to the wide scan range list.
OK Click this so save any changes to the wide scan range list.
Wide Scan Result
This table displays the available frequency band(s) found through the wide scan.
To Next Page
Loading...
