Chapter 7 Network Settings
HES-309M Series User’s Guide
91
7.11.1 Port Trigger Wizard
Use the wizard to create a port trigger rules that will allow the WiMAX Device to to
automate port forwarding and allow computers on local network to provide
services that would normally require a fixed address on the local network.
Click Network Setting > NAT > Port Trigger > Wizard
Figure 37 Port Trigger Wizard Screen
Start / End
Port
This displays the start / end open port for the port trigger rule.
Click Add to create a new, empty rule, then enter the outgoing port
number or range of port numbers that makes the WiMAX Device record
the source IP address and assign it to the selected incoming port
number(s).
To select one port number, enter the port number in the Start Port and
End Port fields.
To select a range of ports,
• enter the port number at the beginning of the range in the Start
Port field
• enter the port number at the end of the range in the End Port field.
If you want to delete this rule, click the Delete icon.
Delete Click this to delete a specified rule.
Wizard Click this to open the port trigger “wizard”.
Add Click this to add a new port trigger rule.
OK Click this to save any changes made to the port trigger list.
Table 30 Port Trigger (continued)
LABEL DESCRIPTION
To Next Page
Loading...
