ZyXEL Communications HES-309M - Configuring DDNS on Your Wimax Device; Configuring Static Route for Routing to Another Network; Testing the DDNS Setting

Chapter 4 Tutorials
HES-309M Series User’s Guide
40
4.8.2 Configuring DDNS on Your WiMAX Device
Configure the following settings in the Network Setting > DDNS screen.
1 Select Enable Dynamic DNS.
2 Select dyndns.org for the
service provider.
3 Select Dynamic for the
service type.
4 Type mywimax.dyndns.org
in the Domain Name field.
5 Enter the user name
(UserName1) and password
(12345).
6 Select WAN IP for the IP update policy.
7 Click Save.
4.8.3 Testing the DDNS Setting
Now you should be able to access the WiMAX Device from the Internet. To test
this:
1 Open a web browser on the computer (using the IP address a.b.c.d) that is
connected to the Internet.
2 Type http://mywimax.dyndns.org and press [Enter].
3 The WiMAX Device’s login page should appear. You can then log into the WiMAX
Device and manage it.
4.9 Configuring Static Route for Routing to
Another Network
In order to extend your Intranet and control traffic flowing directions, you may
connect a router to the WiMAX Device’s LAN. The router may be used to separate
two department networks. This tutorial shows how to configure a static routing
rule for two network routings.