Chapter 3 Setup Wizard
HES-309M Series User’s Guide
24
3.1.2 LAN Settings
The LAN Settings screen allows you to configure your local network options.
Figure 5 Setup Wizard > LAN Settings
The following table describes the labels in this screen.
Table 5 Setup Wizard > LAN Settings
LABEL DESCRIPTION
LAN TCP/IP
IP
Address
Enter the IP address of the WiMAX Device on the LAN.
Note: This field is the IP address you use to access the WiMAX Device
on the LAN. If the web configurator is running on a computer on
the LAN, you lose access to it as soon as you change this field.
You can access the web configurator again by typing the new IP
address in the browser.
IP Subnet
Mask
Enter the subnet mask of the LAN.
DHCP Server
Enable Select this if you want the WiMAX Device to be the DHCP server on the
LAN. As a DHCP server, the WiMAX Device assigns IP addresses to DHCP
clients on the LAN and provides the subnet mask and DNS server
information.
Start IP Enter the IP address from which the WiMAX Device begins allocating IP
addresses.
End IP Enter the IP address at which the WiMAX Device stops allocating IP
addresses.
To Next Page
Loading...
