Chapter 9 Maintenance
HES-309M Series User’s Guide
129
Click Maintenance > Firmware Upgrade > Upgrade File to open this screen
as shown next.
Figure 60 Upgrade File Screen
This screen contains the following fields:
9.11.1 The Firmware Upload Process
When the WiMAX Device uploads new firmware, the process usually takes about
two minutes. The device also automatically restarts in this time. This causes a
temporary network disconnect.
Note: Do not turn off the device while firmware upload is in progress!
After two minutes, log in again, and check your new firmware version in the
Status screen. You might have to open a new browser window to log in.
If the upload is not successful, you will be notified by error message.
Table 50 Upgrade File
LABEL DESCRIPTION
Upgrade File Click Browse then browse to the location of a firmware upgrade file
and select it.
Upgrade Click this to begin uploading the selected file. This may take up to two
minutes.
Note: Do not turn off the device while firmware upload is in
progress!
To Next Page
Loading...
