Chapter 6 WiMAX
HES-309M Series User’s Guide
62
Device
Private Key
Browse for and choose a device private key, if required.
Device
Private Key
Info
This field displays information about the assigned device private key.
Device
Private Key
Password
Enter the device private key, if required.
Inner Mode Sets the EAP-TTLS inner mode.
The WiMAX Device supports the following:
• MS-CHAP v2 - This is version 2 of Microsoft’s variant of Challenge
Handshake Authentication Protocol (CHAP). It allows for mutual
authentication between devices.
• MS-CHAP - This is Microsoft’s variant of Challenge Handshake
Authentication Protocol (CHAP). It allows for mutual authentication
between devices.
• CHAP - The Challenge Handshake Authentication Protocol (CHAP)
uses PPP to authenticate remote devices using a three-way
handshake and shared secret verification.
• MD5 - Message-Digest, algorithm 5, (MD5) encryption is typically
used for checking file integrity. Because this encryption protocol
contains a number of serious security flaws it is generally not
recommended that you use it for authentication security.
• PAP - Password Authentication Protocol uses unencrypted plaintext
to send a passwords for authentication over the network. It’s
probably not a good idea to rely on this for security.
Username Enter the username required for the EAP-TTLS inner method.
Password Enter the password required for the EAP-TTLS inner method.
Options
Enable Auth
Mode
Decoration
in EAP Outer
ID
Select this to enable authentication mode.
Enable
Service
Mode
Decoration
in EAP Outer
ID
Select this to enable service mode.
Random
Outer ID
Select this to allow the WiMAX Device to generate a 16-byte random
number as a username for the EAP Identity Response message.
Ignore Cert
Verification
Select this to ignore base station certification verification when a
certificate is received during EAP-TLS or EAP-TTLS.
Same EAP
OuterID in
ReAuth
Select this to use the same EAP to the outer ID when reauthenticating.
MAC address
in EAP-TLS
outer Id
Adds the MAC address of the WiMAX Device to the outer ID while the
EAP mode is set to EAP-TLS.
Table 12 Authentication Settings (continued)
LABEL DESCRIPTION
To Next Page
Loading...
