Chapter 12 Wireless LAN
NBG-419N v2 User’s Guide
105
See the rest of this chapter for information on the other labels in this screen.
12.4.1 No Security
Select No Security to allow wireless stations to communicate with the access points without any
data encryption.
Note: If you do not enable any wireless security on your Router, your network is
accessible to any wireless networking device that is within range.
Figure 74 Network > Wireless LAN > General: No Security
Channel
Selection
Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box. The options vary depending on the frequency
band and the country you are in.
Refer to the Connection Wizard chapter for more information on channels. This option is
only available if Auto Channel Selection is disabled.
Operating
Channel
This displays the channel the Router is currently using.
Security
Security Mode Select WEP, WPA-PSK or WPA2-PSK to add security on this wireless network. The
wireless clients which want to associate to this network must have same wireless security
settings as the Router. After you select to use a security, additional options appears in this
screen. See 12.4.2 and 12.4.3 sections.
Or you can select No Security to allow any client to associate this network without
authentication.
Note: If you enable the WPS function, only No Security, WPA-PSK and WPA2-PSK are
available in this field.
Apply Click Apply to save your changes back to the Router.
Reset Click Reset to reload the previous configuration for this screen.
Table 42 Network > Wireless LAN > General (continued)
LABEL DESCRIPTION
To Next Page
Loading...
