Chapter 25 Maintenance
NBG-419N v2 User’s Guide
180
The following table describes the labels in this screen.
25.4 Password Screen
It is strongly recommended that you change your Router's password.
If you forget your Router's password (or IP address), you will need to reset the device. See Section
25.8 on page 185 for details.
Click Maintenance > Password. The screen appears as shown.
Figure 129 Maintenance > Password
The following table describes the labels in this screen.
Table 79 Maintenance > General
LABEL DESCRIPTION
System Setup
System Name System Name is a unique name to identify the Router in an Ethernet network.
Domain Name Enter the domain name you want to give to the Router.
Administrator
Inactivity Timer
Type how many minutes a management session can be left idle before the
session times out. The default is 5 minutes. After it times out you have to log in
with your password again. Very long idle timeouts may have security risks. A
value of "0" means a management session never times out, no matter how long
it has been left idle (not recommended).
Apply Click Apply to save your changes back to the Router.
Cancel Click Cancel to begin configuring this screen afresh.
Table 80 Maintenance > Password
LABEL DESCRIPTION
Password Setup Change your Router’s password (recommended) using the fields as shown.
Old Password Type the default password or the existing password you use to access the system in this
field.
New Password Type your new system password (up to 30 characters). Note that as you type a password,
the screen displays an asterisk (*) for each character you type.
Retype to
Confirm
Type the new password again in this field.
Apply Click Apply to save your changes back to the Router.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
