NBG-419N v2 User’s Guide 151
CHAPTER 19
RIP
19.1 Overview
Routing Information Protocol (RIP) is an interior or intra-domain routing protocol that uses
distance-vector routing algorithms. RIP is used on the Internet and is common in the NetWare
environment as a method for exchanging routing information between routers.
19.2 What You Can Do
Use the RIP screen (Section 19.3 on page 151) to enable RIPv1 or RIPv2, which are LAN broadcast
protocols.
19.3 RIP Screen
Use this screen to enable RIPv1 or RIPv2, which are LAN broadcast protocols. Click Network >
RIP. The screen appears as shown.
Figure 106 Network > RIP
The following table describes the labels in this screen.
Table 68 Network > RIP
LABEL DESCRIPTION
RIP Select the RIPv1 or RIPv2 you want the Router to use.
Otherwise select None.
Apply Click Apply to save your changes back to the Router.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
