NBG-419N v2 User’s Guide 189
CHAPTER 26
Troubleshooting
This chapter offers some suggestions to solve problems you might encounter. The potential
problems are divided into the following categories.
• Power, Hardware Connections, and LEDs
• Router Access and Login
• Internet Access
• Resetting the Router to Its Factory Defaults
• Wireless Router/AP Troubleshooting
• ZyXEL Share Center Utility Problems
26.1 Power, Hardware Connections, and LEDs
The Router does not turn on. None of the LEDs turn on.
1 Make sure you are using the power adaptor or cord included with the Router.
2 Make sure the power adaptor or cord is connected to the Router and plugged in to an appropriate
power source. Make sure the power source is turned on.
3 Disconnect and re-connect the power adaptor or cord to the Router.
4 If the problem continues, contact the vendor.
One of the LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the LED. See Section 1.5 on page 17.
2 Check the hardware connections. See the Quick Start Guide.
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Disconnect and re-connect the power adaptor to the Router.
5 If the problem continues, contact the vendor.
To Next Page
Loading...
