Chapter 12 Wireless LAN
NBG-419N v2 User’s Guide
106
The following table describes the labels in this screen.
Refer to Table 42 on page 104 for descriptions of the other labels in this screen.
12.4.2 WEP Encryption
WEP encryption scrambles the data transmitted between the wireless stations and the access points
to keep network communications private. It encrypts unicast and multicast communications in a
network. Both the wireless stations and the access points must use the same WEP key.
Your Router allows you to configure up to four 64-bit or 128-bit WEP keys but only one key can be
enabled at any one time.
In order to configure and enable WEP encryption, click Network > Wireless LAN to display the
General screen. Select Static WEP from the Security Mode list.
Figure 75 Network > Wireless LAN > General: Static WEP
Table 43 Network > Wireless LAN > General: No Security
LABEL DESCRIPTION
Security Mode Choose No Security from the drop-down list box.
Apply Click Apply to save your changes back to the Router.
Cancel Click Cancel to reload the previous configuration for this screen.
To Next Page
Loading...
