ZyXEL Communications NBG-419N v2 - AP Mode Status Screen

Chapter 9 Access Point Mode
NBG-419N v2 User’s Guide
72
9.4 AP Mode Status Screen
Click to open the Status screen.
Figure 50 Status Screen: Access Point Mode
The following table describes the labels shown in the Status screen.
Table 32 Status Screen: Access Point Mode
LABEL DESCRIPTION
Logout Click this at any time to exit the Web Configurator.
Device Information
Host Name This is the System Name you enter in the Maintenance > General screen. It is for
identification purposes.
Firmware Version This is the firmware version and the date created.
Sys OP Mode This is the device mode (Section 6.1.2 on page 49) to which the Router is set - Access
Point Mode.
LAN Information
- MAC Address This shows the LAN Ethernet adapter MAC Address of your device.
- IP Address This shows the LAN port’s IP address.
- IP Subnet Mask This shows the LAN port’s subnet mask.
- DHCP This shows the LAN port’s DHCP role - Server, Client or None.
WLAN Information