Chapter 12 Wireless LAN
NBG-419N v2 User’s Guide
113
12.9 WPS Station Screen
Use this screen when you want to add a wireless station using WPS. To open this screen, click
Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second wireless
station, you have to press these buttons on both device and the wireless station
again after the first 2 minutes.
Figure 81 Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
Table 50 Network > Wireless LAN > WPS Station
LABEL DESCRIPTION
Push Button Use this button when you use the PBC (Push Button Configuration) method to configure
wireless stations’s wireless settings. See Section 11.3.1 on page 88.
Click this to start WPS-aware wireless station scanning and the wireless security information
synchronization.
Or input
station’s PIN
number
Use this button when you use the PIN Configuration method to configure wireless station’s
wireless settings. See Section 11.3.2 on page 89.
Type the same PIN number generated in the wireless station’s utility. Then click Start to
associate to each other and perform the wireless security information synchronization.
To Next Page
Loading...
