ZyXEL Communications NBG-419N v2 - Wireless Security: WPA-PSK;WPA2-PSK

Chapter 3 Connection Wizard
NBG-419N v2 User’s Guide
35
The following table describes the labels in this screen.
3.5.2 Wireless Security: WPA-PSK/WPA2-PSK
Choose WPA-PSK or WPA2-PSK security in the Wireless Security screen to set up a password for
your wireless network.
Figure 18 Wireless Security: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
Table 12 Wireless Security: No Security
LABEL DESCRIPTION
Wireless
Network Name
(SSID)
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless LAN.
If you change this field on the Router, make sure all wireless stations use the same SSID in
order to access the network.
Security mode Select a Security level from the drop-down list box.
Choose None to have no wireless LAN security configured. If you do not enable any wireless
security on your Router, your network is accessible to any wireless networking device that is
within range.
Exit Click this to close the wizard screen without saving.
Back Click this to return to the previous screen.
Next Click this to continue.
Table 13 Wireless Security: WPA-PSK/WPA2-PSK
LABEL DESCRIPTION
Wireless
Network Name
(SSID)
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless LAN.
If you change this field on the Router, make sure all wireless stations use the same SSID in
order to access the network.
Security mode Select a Security level from the drop-down list box.
Choose WPA-PSK or WPA2-PSK security to configure a Pre-Shared Key. Choose this
option only if your wireless clients support WPA-PSK or WPA2-PSK respectively.
Wireless
password
Type from 8 to 63 case-sensitive ASCII characters. You can set up the most secure wireless
connection by configuring WPA in the wireless LAN screens.
Verify Password Retype the password to confirm.
Exit Click this to close the wizard screen without saving.