Chapter 11 Tutorials
NBG-419N v2 User’s Guide
91
11.4 Enabling and Configuring Wireless Security (No WPS)
This example shows you how to configure wireless security settings with the following parameters
on your Router.
Follow the steps below to configure the wireless settings on your Router.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see Section 4.2 on page 37).
1 Open the Wireless LAN > General screen in the AP’s Web Configurator.
2 Make sure the Enable Wireless LAN check box is selected.
3 Enter SSID_Example3 as the SSID and select a channel.
4 Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared
Key field. Click Apply.
Figure 66 Tutorial: Network > Wireless LAN > General
SSID SSID_Example3
Channel 6
Security WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
To Next Page
Loading...
