ZyXEL Communications NBG-419N v2 - The Auto-Connect Printer List Window

Chapter 2 ZyXEL NetUSB Share Center Utility
NBG-419N v2 User’s Guide
24
The following table describes the labels in this window.
2.2.3 The Auto-Connect Printer List Window
This section describes the utility’s auto-connect printer list window. You can open it by clicking the
Tools > Auto-Connect Printer List menu command.
Note: If the computer is connecting to the shared USB printer for the first time, you need
to click Connect and setup the printer before you can use the Auto-Connect
Printer function. See Chapter 11 on page 87 for more details.
Figure 6 ZyXEL NetUSB Share Center Utility Auto-Connect Printer List Window
The following table describes the labels in this screen.
Table 5 ZyXEL NetUSB Share Center Utility Configuration Window
LABEL DESCRIPTION
Basic Select this to run the utility automatically when you log into or start up Windows.
Language Select a language for the ZyXEL NetUSB Share Center Utility. You must restart the utility for
the change to take effect.
OK Click this to save your changes and close the window.
Cancel Click this cancel to close the window without saving.
Apply Click this to save your changes without closing the window.
Table 6 ZyXEL NetUSB Share Center Utility Auto-Connect Printer List Window
LABEL DESCRIPTION
Server IP &
Printer Name
Displays a list of print server IPs and printer names connected to this Router.
Windows
Printer Name
Displays a corresponding list of Windows printer names connected to this devices listed in
the other list.
Delete Select an printer from the list and click this to remove it.
Close Click this to close the window.