Chapter 9 Access Point Mode
NBG-419N v2 User’s Guide
74
9.4.0.1 Navigation Panel
Use the menu in the navigation panel to configure Router features in Access Point mode.
The following screen and table show the features you can configure in Access Point mode.
Figure 51 Menu: Access Point Mode
Refer to Table 31 on page 66 for descriptions of the labels shown in the Navigation panel.
9.5 LAN Screen
Use this section to configure your LAN settings while in Access Point mode.
Click Network > LAN to see the screen below.
Note: If you change the IP address of the Router in the screen below, you will need to log
into the Router again using the new IP address.
Figure 52 Network > LAN > IP
The table below describes the labels in the screen.
To Next Page
Loading...
