Chapter 7 Easy Mode
NBG-419N v2 User’s Guide
52
Click Status to open the following screen screen.
Figure 32 Easy Mode: Status Screen
7.2 What You Can Do
You can do the following in this mode:
•Use this Navigation Panel (Section 7.4 on page 53) to opt out of the Easy mode.
•Use the Network Map screen (Section 7.5 on page 53) to check if your Router can ping the
gateway and whether it is connected to the Internet.
•Use the Control Panel (Section 7.6 on page 54) to configure and enable Router features,
including wireless security, wireless scheduling and bandwidth management and so on.
•Use the Status Screen screen (Section 7.7 on page 61) to view read-only information about the
Router, including the WAN IP, MAC Address of the Router and the firmware version.
7.3 What You Need to Know
Between the different device modes, the Control Panel (Section 7.6 on page 54) changes depending
on which features are applicable to the mode:
• Router Mode: All Control Panel features are available.
• Access Point Mode: Only Power Saving and Wireless Security are available.
• WISP Mode: The available features for this mode are Game Console, Content Filter,
Bandwidth MGMT, and Firewall.
Control Panel
Status Screen
Go to
Network
Map
Screen
Navigation Panel
To Next Page
Loading...
