Chapter 10 WISP Mode
NBG-419N v2 User’s Guide
85
10.5.4 Site Survey Screen
Use this screen to scan for and connect to a wireless network automatically. Go to Configuration >
Site Survey to open the following screen.
Figure 62 Configuration > Wireless LAN > Site Survey (WISP)
The following table describes the labels in this screen.
Table 40 Configuration > Wireless LAN > Site Survey (WISP)
LABEL DESCRIPTION
Station Site Survey
# Select a wireless device and click Add Profile to open a configuration screen where you
can add the selected wireless device to a profile and then enable it.
SSID This displays the SSID of the wireless device.
indicates the wireless device is added to an activated profile and the Router is
connecting to it.
BSSID This displays the MAC address of the wireless device.
Signal Strength This displays the strength of the wireless signal. The signal strength mainly depends on the
antenna output power and the distance between your Router and this device.
Channel This displays the channel number used by this wireless device.
station encryp This displays the data encryption method used by this wireless device.
station auth This displays the authentication method used by this wireless device.
Network Type This displays the network type (In (Infrastructure) or Ad (Ad Hoc) of this wireless device.
Rescan Click this button to search for available wireless devices within transmission range and
update this table.
Setting Select a wireless device and click this button to add it to a profile.
To Next Page
Loading...
