Chapter 10 WISP Mode
NBG-419N v2 User’s Guide
78
Note: After clicking Login, the Easy mode appears. Refer to Section on page 51 for the
Easy mode screens. Click Expert mode to see the screens described in the sections
following this.
10.4 WISP Mode Status Screen
Click to open the status screen.
Figure 56 Status: WISP Mode
The following table describes the labels shown in the Status screen.
Table 34 Status Screen: WISP Mode
LABEL DESCRIPTION
Logout Click this at any time to exit the Web Configurator.
Device Information
Host Name This is the System Name you enter in the Maintenance > General screen. It is for
identification purposes.
Firmware Version This is the firmware version and the date created.
Sys OP Mode This is the device mode (Section 6.1.2 on page 49) to which the Router is set - WISP Mode.
WAN Information
To Next Page
Loading...
