Chapter 22 Bandwidth Management
NBG-419N v2 User’s Guide
166
Table 75 Bandwidth Management Rule Configuration: User-defined Service
See Appendix E on page 261 for commonly used services and port numbers.
22.6 Monitor Screen
Use this screen to view the amount of network bandwidth that applications running in the network
are using.
The bandwidth is measured in kilobits per second (kbps).
LABEL DESCRIPTION
BW Budget Select Maximum Bandwidth or Minimum Bandwidth and specify the maximum or
minimum bandwidth allowed for the rule in kilobits per second.
Destination
Address
Enter the IP address of the destination computer.
The Router applies bandwidth management to the service or application that is entering this
computer.
Destination
Subnet
Netmask
Enter the subnet netmask of the destination of the traffic for which the bandwidth
management rule applies.
Destination
Port
This is the port number of the destination that define the traffic type, for example TCP port
80 defines web traffic.
Source Address Enter the IP address of the computer that initializes traffic for the application or service.
The Router applies bandwidth management to traffic initiating from this computer.
Source Subnet
Netmask
Enter the subnet netmask of the computer initiating the traffic for which the bandwidth
management rule applies.
Source Port This is the port number of the source that define the traffic type, for example TCP port 80
defines web traffic.
Protocol Select the protocol (TCP, UDP, User defined) for which the bandwidth management rule
applies.
If you select User-defined, enter the protocol for which the bandwidth management rule
applies. For example, ICMP for ping traffic.
Apply Click Apply to save your customized settings.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
