Chapter 11 Tutorials
NBG-419N v2 User’s Guide
88
• Push Button Configuration (PBC) - create a secure wireless network simply by pressing a
button. See Section 11.3.1 on page 88.This is the easier method.
• PIN Configuration - create a secure wireless network simply by entering a wireless client's PIN
(Personal Identification Number) in the Router’s interface. See Section 11.3.2 on page 89. This is
the more secure method, since one device can authenticate the other.
11.3.1 Push Button Configuration (PBC)
1 Make sure that your Router is turned on and that it is within range of your computer.
2 Make sure that you have installed the wireless client (this example uses the NWD210N) driver and
utility in your notebook.
3 In the wireless client utility, find the WPS settings. Enable WPS and press the WPS button (Start or
WPS button)
4 Log into Router’s Web Configurator and press the Push Button button in the Network > Wireless
Client > WPS Station screen.
Note: Your Router has a WPS button located on its panel, as well as a WPS button in its
configuration utility. Both buttons have exactly the same function; you can use one
or the other.
Note: It doesn’t matter which button is pressed first. You must press the second button
within two minutes of pressing the first one.
The Router sends the proper configuration settings to the wireless client. This may take up to two
minutes. Then the wireless client is able to communicate with the Router securely.
To Next Page
Loading...
