ZyXEL Communications NBG-419N v2 - Wireless LAN General Screen

Chapter 10 WISP Mode
NBG-419N v2 User’s Guide
80
10.5 Wireless LAN General Screen
Use this screen to configure the wireless LAN settings of your Router. Go to Configuration >
Wireless LAN > General to open the following screen.
Figure 57 WISP Mode: LAN > General Screen
The following table describes the labels in this screen.
Rate For the LAN ports, this displays the port speed and duplex setting or N/A when the line is
disconnected.
For the WAN port, it displays the port speed and duplex setting if you’re using Ethernet
encapsulation and Idle (line (ppp) idle), Dial (starting to trigger a call) and Drop (dropping
a call) if you're using PPPoE or PPTP encapsulation. This field displays N/A when the line is
disconnected.
For the WLAN, it displays the maximum transmission rate when the WLAN is enabled and N/
A when the WLAN is disabled.
Summary
BW MGMT Monitor Click Details... to go to the Monitor > BW MGMT Monitor screen (Section 5.4 on page
45). Use this screen to view the amount of network bandwidth that applications running in
the network are using.
DHCP Table Click Details... to go to the Monitor > DHCP Table screen (Section 5.5 on page 45). Use
this screen to view current DHCP client information.
Packet Statistics Click Details... to go to the Monitor > Packet Statistics screen (Section 5.6 on page 46).
Use this screen to view port status and packet specific statistics.
Table 34 Status Screen: WISP Mode (continued)
LABEL DESCRIPTION
Table 35 WISP Mode: LAN > General Screen
LABEL DESCRIPTION
Wireless Setup
Network Name
(SSID)
Enter the name of the access point to which you are connecting.
Security
Security Mode Select the security mode of the access point to which you want to connect.
Apply Click Apply to save your changes back to the Router.
Reset Click Reset to reload the previous configuration for this screen.