ZyXEL Communications NBG-419N v2 - Page 122

Chapter 13 WAN
NBG-419N v2 User’s Guide
122
This screen displays when you select PPPoE encapsulation.
Figure 87 Network > WAN > Internet Connection: PPPoE Encapsulation
The following table describes the labels in this screen.
Table 54 Network > WAN > Internet Connection: PPPoE Encapsulation
LABEL DESCRIPTION
ISP Parameters for Internet Access
Encapsulation Select PPP over Ethernet if you connect to your Internet via dial-up.
User Name Type the user name given to you by your ISP.
Password Type the password associated with the user name above.
Retype to
Confirm
Type your password again to make sure that you have entered is correctly.
MTU Size Enter the Maximum Transmission Unit (MTU) or the largest packet size per frame that your
Router can receive and process.
Nailed-Up
Connection
Select Nailed-Up Connection if you do not want the connection to time out.
Idle Timeout
(sec)
This value specifies the time in minutes that elapses before the router automatically
disconnects from the PPPoE server.
WAN IP Address Assignment
Get automatically
from ISP
Select this option If your ISP did not assign you a fixed IP address. This is the default
selection.