Chapter 1 Getting to Know Your Router
NBG-419N v2 User’s Guide
19
3 If using screw anchors, drill two holes for the screw anchors into the wall. Push the
anchors into the full depth of the holes, then insert the screws into the anchors. Do not
insert the screws all the way in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not
insert the screws all the way in - leave a gap of about 0.5 cm.
4 Make sure the screws are fastened well enough to hold the weight of the Router with the
connection cables.
5 Align the holes on the back of the Router with the screws on the wall. Hang the Router on
the screws.
Figure 2 Wall Mounting Example
To Next Page
Loading...
