Chapter 11 Tutorials
NBG-419N v2 User’s Guide
95
1 After the first computer (A) finishes using the USB device, click Disconnect on the Utilty to
unmount it.
2 Click Connect on the Utility of the second computer (B) to mount the USB device on B.
3 If A does not disconnect from the USB device, B cannot use it. B can click the Request to Connect
button to request A to disconnect. B will see the following message on its Utility:
4 A will receive the following message on its Utility screen.
5 A should click Accept to disconnect to the USB device.
6 After A is disconnected from USB device, B will see the following message on its Utility. Now B can
access the USB device.
Note: If your computer is connected to a USB device, you must disconnect it and use Exit
to close the Utility. If you use the X on the Utility screen, it only closes the Utility
window. The Utility is still connected. Do not exit the Utility until the USB device is
disconnected via the Utility or until you receive a request to disconnect. See
Chapter 2 on page 20 for details on how to exit the Utility.
To Next Page
Loading...
