Chapter 6 Monitor
NXC Series User’s Guide
101
Note: It is highly recommended that you register the AP with the NCC before pressing the
Nebula button to change its management mode.
To access this screen, select a tri-mode AP from the list and click the Nebula button in the Monitor >
Wireless > AP Information > AP List screen.
Figure 57 Monitor > Wireless > AP Information > AP List > Change mode behavior
The following table describes the labels in this screen.
Table 43 Monitor > Wireless > AP Information > AP List > Change mode behavior
LABEL DESCRIPTION
Change to cloud
mode with retain
current IP and VLAN
settings.
Select this option to have the AP run in Nebula cloud management mode without
changing its IP address and VLAN settings.
Change to cloud
mode with specific IP
and VLAN settings
Select this option to have the AP run in Nebula cloud management mode using the IP
address and VLAN settings you configure below.
Get Automatically Select this to make the AP a DHCP client and automatically get the IP address, subnet
mask, and gateway address from a DHCP server.
Use Fixed IP
Address
Select this if you want to specify the IP address, subnet mask, gateway and DNS server
address manually.
VLAN ID Enter a management VLAN ID for the AP.
Untagged/Tagged Set whether the AP adds the VLAN ID to outbound traffic transmitted through its Ethernet
port.
IP Address Enter the IP address for the AP.
Subnet Mask Enter the subnet mask of the AP in dot decimal notation. The subnet mask indicates what
part of the IP address is the same for all devices in the network.
Gateway Enter the IP address of the gateway. The AP sends packets to the gateway when it does
not know how to route the packet to its destination. The gateway should be on the same
network as the AP.
DNS Enter the IP address of the DNS server.
To Next Page
Loading...
