Chapter 8 Wireless
NXC Series User’s Guide
120
8.2 Controller
Use this screen to set how the NXC allows new APs to connect to the network. Click Configuration >
Wireless > Controller to access this screen.
Figure 68 Configuration > Wireless > Controller
Each field is described in the following table.
8.3 AP Management
Use the AP Management screens to manage all of the APs connected to the NXC.
Table 54 Configuration > Wireless > Controller
LABEL DESCRIPTION
Controller Setting
Country Code Select the country where the NXC is located/installed.
Registration
Type
Select Manual to add each AP to the NXC for management, or Always Accept to automatically
add APs to the NXC for management.
Note: Select the Manual option for managing a specific set of APs. This is
recommended as the registration mechanism cannot automatically differentiate
between friendly and rogue APs. For details on how to handle rogue APs, see
Section 6.16 on page 109.
APs must be connected to the NXC by a wired connection or network.
Apply Click Apply to save your changes back to the NXC.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
