ZyXEL Communications NXC5500 - Auth. Policy Group Add;Edit

Chapter 15 Captive Portal
NXC Series User’s Guide
223
15.5.1 Auth. Policy Group Add/Edit
This screen allows you to add authentication policy groups for managed AP groups. Click the Add or
Edit button (for an existing policy) in the Authentication Policy Group table on the Captive Portal >
Redirect on AP screen to access this screen.
Figure 129 Configuration > Captive Portal > Redirect on AP: Auth. Policy Group Add/Edit
The following table describes the labels in this screen.
Table 100 Configuration > Captive Portal > Redirect on AP: Auth. Policy Group Add/Edit
LABEL DESCRIPTION
General Settings
Profile Name Enter a name for this policy group. You can use up to 31 alphanumeric characters. Dashes and
underscores are also allowed. The name should start with a letter.
Description Enter an optional description of the authentication policy group. You can enter up to 60
characters.
Add Click this to create a new entry.
Edit
Select an entry and click Edit to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The NXC confirms you want to remove it before
doing so.
Move Click this to assign the selected policy group a new priority.
When you click the button, an entry box opens beside it. Enter the priority value, then press
[Enter].
# This indicates the priority of a policy group.
Priority values are unique to each policy group. If you want to adjust the priority, use the Move
button.
Name This field displays the name of the authentication policy that is added to this group. You can
click the name to make it editable.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to exit this screen without saving.