Chapter 15 Captive Portal
NXC Series User’s Guide
221
15.5 Redirect on AP
Use this screen to configure the authentication policy rules for traffic from SSIDs in local bridge mode
and used by the managed APs. Click Configuration > Captive Portal > Redirect on AP to access this
screen.
Note: To apply an authentication policy rule to a specific SSID, make sure the SSID is set to
work in local bridge forwarding mode and associated with an AP group. You also need
to add the authentication policy rule to an authentication policy group, and apply the
policy group to the AP group with which the SSID is associated.
Figure 128 Configuration > Captive Portal > Redirect on AP
Self-serviced Select this option to allow clients themselves to scan the QR code (printed out by the
administrator) to log into the web site.
QR Portal
Address
Select a VLAN interface on the NXC, through which the client is allowed to access the NXC.
Note
Message
Enter the notes you want to display along with the QR code.
QR Code Click the Print Out QR Code button to view and print the QR code.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to exit this screen without saving.
Table 98 Configuration > Captive Portal > Redirect on Controller: Add/Edit
LABEL DESCRIPTION
To Next Page
Loading...
