Chapter 6 Monitor
NXC Series User’s Guide
102
6.12 Radio List
Use this screen to view statistics about the wireless radio transmitters in each of the APs connected to the
NXC. To access this screen, click Monitor > Wireless > AP Information > Radio List.
Figure 58 Monitor > Wireless > AP Information > Radio List
The following table describes the labels in this screen.
OK Click OK to save your changes back to the AP.
Note: The AP will be set to Nebula cloud management mode and removed
from the managed AP list right after you click OK.
Cancel Click Cancel to exit this screen without saving your changes.
Table 43 Monitor > Wireless > AP Information > AP List > Change mode behavior
LABEL DESCRIPTION
Table 44 Monitor > Wireless > AP Information > Radio List
LABEL DESCRIPTION
Hide/Show
Advanced
Settings
Click this button to display a greater or lesser number of configuration fields.
Radio List
Enable Column
Freeze
Select the check box to freeze the first column (#) so it will be always visible when you scroll
through the list. Clear the check box to unfreeze the column.
More Information Click this to view additional information about the selected radio’s SSID(s), wireless traffic and
wireless clients. Information spans a 24 hour period.
Slot This is the radio’s index number in this list.
Loading This indicates the AP’s load balance status (AP UnderLoaded or AP OverLoaded) when load
balancing is enabled on the AP. Otherwise, it shows - when load balancing is disabled or the
radio is in monitor mode.
AP Description This displays the description of the AP to which the radio belongs.
Frequency Band This indicates the wireless frequency currently being used by the radio.
This shows - when the radio is in monitor mode.
To Next Page
Loading...
