Chapter 6 Monitor
NXC Series User’s Guide
78
The following table displays the maximum number of records shown in the report, the byte count limit,
and the hit count limit.
6.6 Session Monitor
This screen displays information about active sessions for debugging or statistical analysis. It is not
possible to manage sessions in this screen. The following information is displayed.
• User who started the session
• Protocol or service port used
•Source IP address
• Destination IP address
• Number of bytes received (so far)
• Number of bytes transmitted (so far)
• Duration (so far)
You can look at all the active sessions by user, service, source IP address, or destination IP address. You
can also filter the information by user, protocol / service or service group, source address, and/or
destination address and view it by user.
Click Monitor > System Status > Session Monitor to display the following screen.
Web Site This field displays the domain names most often visited. The NXC counts each page viewed on
a Web site as another hit. The maximum number of domain names in this report is indicated in
Table 28 on page 78.
Hits This field displays how many hits the Web site received. The NXC counts hits by counting HTTP
GET packets. Many Web sites have HTTP GET references to other Web sites, and the NXC counts
these as hits too. The count starts over at zero if the number of hits passes the hit count limit. See
Table 28 on page 78.
Table 28 Maximum Values for Reports
LABEL DESCRIPTION
Maximum Number of Records 20
Byte Count Limit 2
64
bytes; this is just less than 17 million terabytes.
Hit Count Limit 2
64
hits; this is over 1.8 x 10
19
hits.
Table 27 Monitor > System Status > Traffic Statistics (continued)
LABEL DESCRIPTION
To Next Page
Loading...
