ZyXEL Communications NXC5500 - Mgmt. AP List

Chapter 8 Wireless
NXC Series User’s Guide
121
8.3.1 Mgmt. AP List
This screen shows the APs that are connected to and can be managed by the NXC. Click Configuration
> Wireless > AP Management to access this screen.
Figure 69 Configuration > Wireless > AP Management > Mgmt. AP List
Each field is described in the following table.
Table 55 Configuration > Wireless > AP Management > Mgmt. AP List
LABEL DESCRIPTION
Hide/Show
Advanced Settings
Click this button to display a greater or lesser number of configuration fields.
AP List Select the type of APs you want to display.
Select All to show all kinds of APs that are currently or used to be connected to the NXC.
Select NebulaFlexPRO to show the APs that can work in Nebula cloud management mode.
Status Select the status of APs you want to display.
Keyword Enter a keyword to display the APs that include it in their AP information, such as model
number, firmware version, MAC address and so on. This field is case-sensitive.
Search Click this to update the list of APs based on the search criteria.
Your search criteria is retained when navigating between screens.
Reset Click this to return the search criteria to the factory defaults and display all currently or
previously connected APs without a filter.
Enable Column
Freeze
Select the check box to freeze the first column (#) so it will be always visible when you scroll
through the list. Clear the check box to unfreeze the column.
Edit the selected rule Select an AP and click this to change the selected AP’s properties, such as its group, radio,
VLAN and port settings.
Add to Mgmt AP List Select an AP and click this to add the selected AP to the managed AP list.
Reboot device Select one or multiple APs and click this button to force the AP(s) to restart.
Remove the
selected rule
Select one or multiple APs and click this button to remove the AP(s) from the manged AP
list.
Note: If in the Configuration > Wireless > Controller screen you set the Registration
Type to Always Accept, then as soon as you remove an AP from this list it
reconnects.