Chapter 6 Monitor
NXC Series User’s Guide
80
6.7 IP/MAC Binding Monitor
Click Monitor > System Status > IP/MAC Binding to display the following screen. This screen lists the
devices that have received an IP address from NXC interfaces with IP/MAC binding enabled and have
ever established a session with the NXC. Devices that have never established a session with the NXC do
not display in the list.
Figure 45 Monitor > System Status > IP/MAC Binding
The following table describes the labels in this screen.
User This field displays the user in each active session.
If you are looking at the sessions by users (or all sessions) report, click + or - to display or hide
details about a user’s sessions.
Service This field displays the protocol used in each active session.
If you are looking at the sessions by services report, click + or - to display or hide details about
a protocol’s sessions.
Source This field displays the source IP address and port in each active session.
If you are looking at the sessions by source IP report, click + or - to display or hide details about
a source IP address’s sessions.
Destination This field displays the destination IP address and port in each active session.
If you are looking at the sessions by destination IP report, click + or - to display or hide details
about a destination IP address’s sessions.
Rx This field displays the amount of information received by the source in the active session.
Tx This field displays the amount of information transmitted by the source in the active session.
Duration This field displays the length of the active session in seconds.
Table 29 Monitor > System Status > Session Monitor (continued)
LABEL DESCRIPTION
Table 30 Monitor > System Status > IP/MAC Binding
LABEL DESCRIPTION
Monitor Table
Interface Select a NXC interface that has IP/MAC binding enabled to show to which devices it has
assigned an IP address.
To Next Page
Loading...
