Chapter 6 Monitor
NXC Series User’s Guide
92
6.11.2 Edit AP List
Use this screen to change the group and radio, VLAN, and port settings of the connected AP. To access
this screen, select an entry and click the Edit the selected rule button in the AP List screen.
Non Support If any of the NXC’s settings for the AP are not supported by the AP, this field displays which
settings are not supported. It displays n/a if all the settings are supported by the AP.
Port Status
Port This shows the name of the physical Ethernet port on the AP.
Status This field displays the current status of each physical port on the AP.
Down - The port is not connected.
Speed / Duplex - The port is connected. This field displays the port speed and duplex setting
(Full or Half).
PVID This shows the port’s PVID.
A PVID (Port VLAN ID) is a tag that adds to incoming untagged frames received on a port so
that the frames are forwarded to the VLAN group that the tag defines.
Up Time This field displays how long the physical port has been connected.
Tx Bcast This field displays the number of broadcast packets transmitted on the port.
Rx Bcast This field displays the number of broadcast packets received on the port.
VLAN Configuration
Name This shows the name of the VLAN.
Status This displays whether or not the VLAN is activated.
VID This shows the VLAN ID number.
Member This field displays the Ethernet port(s) that is a member of this VLAN.
Ethernet Neighbor
Local
Port(Description)
This field displays the port of the AP, on which the neighboring device is discovered.
Model Name This field displays the model name of the discovered device.
System Name This field displays the system name of the discovered device.
Firmware Version This field displays the firmware version of the discovered device.
Port(Description) This field displays the discovered device’s port which is connected to the AP.
IP Address This field displays the IP address of the discovered device. Click the IP address to access and
manage the discovered device using the web configurator.
MAC Address This field displays the MAC address of the discovered device.
Station Count The y-axis represents the number of connected stations.
The x-axis shows the time over which a station was connected.
Last Update This field displays the date and time the information in the window was last updated.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to close the window with changes unsaved.
Table 38 Monitor > Wireless > AP Information > AP List > AP Information (continued)
LABEL DESCRIPTION
To Next Page
Loading...
