Chapter 14 IP/MAC Binding
NXC Series User’s Guide
201
14.2.2 Add/Edit Static DHCP Rule
Click Configuration > Network > IP/MAC Binding > Edit to open this screen. Click the Add or Edit icon to
open the following screen. Use this screen to configure an interface’s IP to MAC address binding
settings.
Figure 110 Configuration > Network > IP/MAC Binding > Edit > Add/Edit
The following table describes the labels in this screen.
14.3 IP/MAC Binding Exempt List
Click Configuration > Network > IP/MAC Binding > Exempt List to open the IP/MAC Binding Exempt List
screen. Use this screen to configure ranges of IP addresses to which the NXC does not apply IP/MAC
binding.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to exit this screen without saving.
Table 87 Configuration > Network > IP/MAC Binding > Edit (continued)
LABEL DESCRIPTION
Table 88 Configuration > Network > IP/MAC Binding > Edit > Add/Edit
LABEL DESCRIPTION
Interface Name This field displays the name of the interface within the NXC and the interface’s IP address and
subnet mask.
IP Address Enter the IP address that the NXC is to assign to a device with the entry’s MAC address.
MAC Address Enter the MAC address of the device to which the NXC assigns the entry’s IP address.
Description Enter up to 64 printable ASCII characters to help identify the entry. For example, you may want
to list the computer’s owner.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
