Chapter 2 Hardware Installation and Connection
NXC Series User’s Guide
27
3 After attaching both mounting brackets, position the NXC in the rack by lining up the holes in the
brackets with the appropriate holes on the rack. Secure the NXC to the rack with the rack-mounting
screws.
2.4 Wall-mounting
Do the following to mount your NXC on a wall.
1 Drill two holes a distance D = 206 mm apart into a wall - see Figure 5 on page 28.
2 Place two screw anchors in the holes. Screw two screws into the screw anchors. Do not screw the screws
all the way in to the wall; leave a small gap between the head of the screw and the wall.
3 The gap must be big enough for the screw heads to slide into the screw slots and the power cord to run
down the back of the NXC.
Note: Make sure the screws are securely fixed to the wall and strong enough to hold the
weight of the NXC with the connection cables.
4 Use the mounting holes on the NXC to hang the NXC on the screws.
Wall-mount the NXC with the Ethernet ports facing down and the
ventilation holes on the side.
To Next Page
Loading...
