Chapter 29 System
NXC Series User’s Guide
370
29.11.4 Adding or Editing an SNMPv3 User Profile
This screen allows you to add or edit an SNMPv3 user profile. To access this screen, click the
Configuration > System > SNMP screen’s Add button or select a SNMPv3 user profile from the list and
click the Edit button.
Trap CAPWAP
Event
Select this option to have the NXC send a trap to the SNMP manager when a managed AP is
connected to or disconnected from the NXC.
SNMPv2c Select this to allow SNMP managers using SNMPv2c to access the NXC.
Get Community Enter the Get Community, which is the password for the incoming Get and GetNext requests
from the management station. The default is public and allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests from the
management station. The default is private and allows all requests.
SNMPv3 Select this to allow SNMP managers using SNMPv3 to access the NXC.
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The NXC confirms you want to remove it before
doing so. Note that subsequent entries move up by one when you take this action.
# This the index number of an SNMPv3 user profile.
User This is the name of the user for which this SNMPv3 user profile is configured.
Authentication This field displays the type of authentication the SNMPv3 user must use to connect to the NXC
using this SNMPv3 user profile.
Privacy This field displays the type of encryption the SNMPv3 user must use to connect to the NXC using
this SNMPv3 user profile.
Privilege This field displays whether the SNMPv3 user can have read-only or read and write access to the
NXC using this SNMPv3 user profile.
Service Control This specifies from which computers you can access which NXC zones.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after the
selected entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The NXC confirms you want to remove it before
doing so. Note that subsequent entries move up by one when you take this action.
Move To change an entry’s position in the numbered list, select the method and click Move to display
a field to type a number for where you want to put it and press [ENTER] to move the rule to the
number that you typed.
# This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the NXC’s (non-configurable) default policy.
The NXC applies this to traffic that does not match any other configured rule. It is not an
editable rule. To apply other behavior, configure a rule that traffic will match so the NXC will not
have to use the default policy.
Zone This is the zone on the NXC the user is allowed or denied to access.
Address This is the object name of the IP address(es) with which the computer is allowed or denied to
access.
Action This displays whether the computer with the IP address specified above can access the NXC
zone(s) configured in the Zone field (Accept) or not (Deny).
Apply Click Apply to save your changes back to the NXC.
Reset Click Reset to return the screen to its last-saved settings.
Table 179 Configuration > System > SNMP (continued)
LABEL DESCRIPTION
To Next Page
Loading...
