ZyXEL Communications NXC5500 - Service Control Rules

Chapter 29 System
NXC Series User’s Guide
350
29.7.5 Service Control Rules
Click Add or Edit in the Service Control table in a WWW, SSH, TELNET, FTP or SNMP screen to add a service
control rule.
Figure 208 Configuration > System > Service Control Rule > Add/Edit
The following table describes the labels in this screen.
Address This is the object name of the IP address(es) with which the computer is allowed or denied
to access.
Action This displays whether the computer with the IP address specified above can access the
NXC zone(s) configured in the Zone field (Accept) or not (Deny).
Authentication
Client Authentication
Method
Select a method the HTTPS or HTTP server uses to authenticate a client.
You must have configured the authentication methods in the Auth. method screen.
Apply Click Apply to save your changes back to the NXC.
Reset Click Reset to return the screen to its last-saved settings.
Table 173 Configuration > System > WWW > Service Control (continued)
LABEL DESCRIPTION
Table 174 Configuration > System > Service Control Rule > Add/Edit
LABEL DESCRIPTION
Create new
Object
Use this to configure any new settings objects that you need to use in this screen.
Address Object Select ALL to allow or deny any computer to communicate with the NXC using this service.
Select a predefined address object to just allow or deny the computer with the IP address that
you specified to access the NXC using this service.
Zone Select ALL to allow or prevent any NXC zones from being accessed using this service.
Select a predefined NXC zone on which a incoming service is allowed or denied.
Action Select Accept to allow the user to access the NXC from the specified computers.
Select Deny to block the user’s access to the NXC from the specified computers.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.