Chapter 8 Wireless
NXC Series User’s Guide
131
8.3.3 AP Group
Use this screen to configure AP groups, which define the radio, port, VLAN and load balancing settings
and apply the settings to all APs in the group. An AP can belong to one AP group at a time. Click
Configuration > Wireless > AP Management > AP Group to access this screen.
Figure 72 Configuration > Wireless > AP Management > AP Group
Primary Controller Specify the IP address of the primary AP controller if you set Override Type to Manual.
Secondary Controller Specify the IP address of the secondary AP controller if you set Override Type to Manual.
Fall back to Primary
Controller when
possible
Select this option to have the managed AP(s) change back to associate with the primary
AP controller as soon as the primary AP controller is available.
Fall Back Check
Interval
Set how often the managed AP(s) check whether the primary AP controller is available.
Firmware Updating
Updating Method Specify how you want the NXC to upgrade AP firmware.
Select CAPWAP to have the NXC use CAPWAP to automatically update firmware on the
managed APs.
Select FTP to allow the managed APs to download the latest firmware from the NXC using
FTP.
Updating Mode Select Auto so the NXC checks the AP’s firmware version and updates it automatically to
the NXC’s latest supported version.
Select Manual so you update the AP firmware manually.
Apply Click Apply to save your changes back to the NXC.
Reset Click Reset to return the screen to its last-saved settings.
Table 57 Configuration > Wireless > AP Management > AP Policy (continued)
LABEL DESCRIPTION
To Next Page
Loading...
