Chapter 1 Introduction
NXC Series User’s Guide
20
1.2.1 Interface Types
There are two types of interfaces in the NXC. In addition to being used in various features, interfaces also
describe the network that is directly connected to it.
• Ethernet interfaces are the foundation for defining other interfaces and network policies.
• VLAN interfaces recognize tagged frames. The NXC automatically adds or removes the tags as
needed. Each VLAN can only be associated with one Ethernet interface.
Note: By default, all Ethernet interfaces are placed into vlan0, allowing the NXC to function as
a bridge device.
1.2.2 Interface and Zone Configuration
This section introduces the NXC’s default zone member physical interfaces and the default
configuration of those interfaces. This section uses the NXC5500 drawings as an example.
Figure 1 Default Network Topology
Table 3 Default Interfaces Configuration
• The LAN zone contains the ge1~ ge6 interfaces (physical ports P1~P6). By default, all LAN interfaces
are put in vlan0.
• The console port is not in a zone and can be directly accessed by a computer attached to it using a
special console-to-Ethernet adapter.
PORT INTERFACE ZONE
IP ADDRESS AND DHCP
SETTINGS
SUGGESTED USE WITH DEFAULT
SETTINGS
P1~P6 ge1~ge6 LAN
(vlan0)
192.168.1.1, DHCP server disabled Dedicated LAN connections
CONSOLE N/A None None Local management
To Next Page
Loading...
