Chapter 29 System
NXC Series User’s Guide
364
29.8.5.2 Example 2: Linux
This section describes how to access the NXC using the OpenSSH client program that comes with most
Linux distributions.
1 Test whether the SSH service is available on the NXC.
Enter “telnet 192.168.1.1 22” at a terminal prompt and press [ENTER]. The computer attempts to
connect to port 22 on the NXC (using the default IP address of 192.168.1.1).
A message displays indicating the SSH protocol version supported by the NXC.
Figure 220 SSH Example 2: Test
2 Enter “ssh –1 192.168.1.1”. This command forces your computer to connect to the NXC using SSH
version 1. If this is the first time you are connecting to the NXC using SSH, a message displays prompting
you to save the host information of the NXC. Type “yes” and press [ENTER].
Then enter the password to log in to the NXC.
Figure 221 SSH Example 2: Log in
3 The CLI screen displays next.
29.9 Telnet
You can use Telnet to access the NXC’s command line interface. Specify which zones allow Telnet
access and from which IP address the access can come. Click Configuration > System > TELNET to
configure your NXC for remote Telnet access. Use this screen to specify from which zones Telnet can be
used to manage the NXC. You can also specify from which IP addresses the access can come.
$ telnet 192.168.1.1 22
Trying 192.168.1.1...
Connected to 192.168.1.1.
Escape character is '^]'.
SSH-1.5-1.0.0
$ ssh –1 192.168.1.1
The authenticity of host '192.168.1.1 (192.168.1.1)' can't be established.
RSA1 key fingerprint is 21:6c:07:25:7e:f4:75:80:ec:af:bd:d4:3d:80:53:d1.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added '192.168.1.1' (RSA1) to the list of known hosts.
Administrator@192.168.1.1's password:
To Next Page
Loading...
