Chapter 19 AP Profile
NXC Series User’s Guide
277
The following table describes the labels in this screen.
19.3.4 Layer-2 Isolation List
This screen allows you to create and manage layer-2 isolation profiles that can be used by your SSIDs. To
access this screen click Configuration > Object > AP Profile > SSID > Layer-2 Isolation List.
If a device’s MAC addresses is NOT listed in a layer-2 isolation profile, it is blocked from communicating
with other devices in an SSID on which layer-2 isolation is enabled.
Note: You can have a maximum of 32 layer-2 isolation profiles on the NXC.
Figure 159 Configuration > Object > AP Profile > SSID > Layer-2 Isolation List
The following table describes the labels in this screen.
Table 129 SSID > MAC Filter List > Add/Edit MAC Filter Profile
LABEL DESCRIPTION
Profile Name Enter up to 31 alphanumeric characters for the profile name. This name is only visible in the Web
Configurator and is only for management purposes. Spaces are not allowed.
Filter Action Select allow to permit the wireless client with the MAC addresses in this profile to connect to the
network through the associated SSID; select deny to block the wireless clients with the specified
MAC addresses.
Add Click this to add a MAC address to the profile’s list.
Edit Click this to edit the selected MAC address in the profile’s list.
Remove Click this to remove the selected MAC address from the profile’s list.
# This field is a sequential value, and it is not associated with a specific profile.
MAC This field specifies a MAC address associated with this profile.
Description This field displays a description for the MAC address associated with this profile. You can click the
description to make it editable. Enter up to 60 characters, spaces and underscores allowed.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to exit this screen without saving your changes.
Table 130 Configuration > Object > AP Profile > SSID > Layer-2 Isolation List
LABEL DESCRIPTION
Layer-2 Isolation List Summary
Add Click this to add a new layer-2 isolation profile.
Edit Click this to edit the selected layer-2 isolation profile.
Remove Click this to remove the selected layer-2 isolation profile.
To Next Page
Loading...
