Chapter 2 Hardware Installation and Connection
NXC Series User’s Guide
26
Figure 4 Attach Rubber Feet
2.3 Rack-mounted Installation
The NXC can be mounted on an EIA standard size, 19-inch rack or in a wiring closet with other
equipment. Follow the steps below to mount your NXC on a standard EIA rack using a rack-mounting kit.
Make sure the rack will safely support the combined weight of all the equipment it contains and that the
position of the NXC does not make the rack unstable or top-heavy. Take all necessary precautions to
anchor the rack securely before installing the unit.
Note: Zyxel provides a sliding rail accessory for your use with your device. Please contact your
local vendor for details.
Use a #2 Phillips screwdriver to install the screws.
2.3.1 Rack-Mounted Installation Procedure
This section uses the NXC5500 drawings as an example.
1 Align one bracket with the holes on one side of the NXC and secure it with the included bracket screws
(smaller than the rack-mounting screws).
2 Attach the other bracket in a similar fashion.
To Next Page
Loading...
