Chapter 9 Interfaces
NXC Series User’s Guide
156
9.2.2 Object References
When a configuration screen includes an Object References icon, select a configuration object and
click Object References to open the Object References screen. This screen displays which configuration
settings reference the selected object. The fields shown vary with the type of object.
Figure 85 Object References
The following table describes labels that can appear in this screen.
9.2.3 Add DHCPv6 Request Options
When you configure an interface as a DHCPv6 client, you can additionally add DHCPv6 request options
which have the NXC to add more information in the DHCPv6 packets. To open the screen, click
Configuration > Network > Interface > Ethernet > Edit, set DHCPv6 to Client in the DHCPv6 Setting section,
and then click Add in the DHCPv6 Request Options table.
Select a DHCPv6 request object in the Select one object field and click OK to save it. Click Cancel to
exit without saving the setting.
Table 66 Object References
LABEL DESCRIPTION
Object Name This identifies the object for which the configuration settings that use it are displayed. Click the
object’s name to display the object’s configuration screen in the main window.
# This field is a sequential value, and it is not associated with any entry.
Service This is the type of setting that references the selected object. Click a service’s name to display
the service’s configuration screen in the main window.
Priority If it is applicable, this field lists the referencing configuration item’s position in its list, otherwise N/
A displays.
Name This field identifies the configuration item that references the object.
Description If the referencing configuration item has a description configured, it displays here.
Refresh Click this to update the information in this screen.
Cancel Click Cancel to close the screen.
To Next Page
Loading...
