ZyXEL Communications NXC5500 - Page 110

Chapter 6 Monitor
NXC Series User’s Guide
110
Figure 63 Monitor > Wireless > Detected Device
The following table describes the labels in this screen.
Table 50 Monitor > Wireless > Detected Device
LABEL DESCRIPTION
Discovered APs
Rogue AP This shows how many devices are detected as rogue APs.
Suspected rogue
AP
This shows how many devices are detected as possible rogue APs by classification rule.
Friendly AP This shows how many devices are detected as friendly APs.
Un-classified AP This shows how many devices are detected, but have not been classified by the NXC.
Detect Now Click this button for the NXC to scan for APs in the network.
Detected Device
Mark as Rogue
AP
Click this button to mark the selected AP as a rogue AP. A rogue AP can be contained in the
Configuration > Wireless > Rogue AP screen (Chapter 8 on page 119).
Mark as Friendly
AP
Click this button to mark the selected AP as a friendly AP. For more on managing friendly APs,
see the Configuration > Wireless > Rogue AP screen (Chapter 8 on page 119).
# This is the station’s index number in this list.
Role This indicates the detected device’s role (such as rogue, friendly or suspected rogue).
Classified by This indicates the detected device’s classification rule.
MAC Address This indicates the detected device’s MAC address.
SSID Name This indicates the detected device’s SSID.
Channel ID This indicates the detected device’s channel ID.
802.11 Mode This indicates the 802.11 mode (a/b/g/n/ac/ax) transmitted by the detected device.
Security This indicates the encryption method (if any) used by the detected device.
Seen by This indicates which AP detects the device.
If an AP in monitor mode detected this AP, this column will show “N/A”.
If an AP using Rogue AP Detection detected this device, it will show the name of the AP and the
signal strength from the detected device. If the wireless device is detected by more than one
AP, only the top 5 APs with the highest signal strength will be shown.
Group This indicates which group the detected device belongs.
Description This displays the detected device’s description. For more on managing friendly and rogue APs,
see the Configuration > Wireless > Rogue AP screen (Chapter 8 on page 119).