Chapter 32 Diagnostics
NXC Series User’s Guide
406
Figure 247 Maintenance > Diagnostics > Packet Capture > Capture on Controller
The following table describes the labels in this screen.
Table 198 Maintenance > Diagnostics > Packet Capture > Capture on Controller
LABEL DESCRIPTION
Interfaces Enabled interfaces appear under Available Interfaces. Select interfaces for which to
capture packets and click the right arrow button to move them to the Capture
Interfaces list. Use the [Shift] and/or [Ctrl] key to select multiple objects.
Filter
IP Version Select the version of the Internet Protocol (IP) by which traffic is routed across the
networks and Internet. Select any to capture packets for traffic sent by either IP version.
Protocol Type Select the protocol type of traffic for which to capture packets. Select any to capture
packets for all types of traffic.
Host IP Select a host IP address object for which to capture packets. Select any to capture
packets for all hosts. Select User Defined to be able to enter an IP address.
Host Port This field is configurable when you set the Protocol Type to any, tcp, or udp. Specify the
port number of traffic to capture.
Misc setting
Continuously capture
and overwrite old ones
Select this to have the NXC keep capturing traffic and overwriting old packet capture
entries when the available storage space runs out.
To Next Page
Loading...
