Chapter 6 Monitor
NXC Series User’s Guide
99
6.11.2.2 Port Setting Edit
Use this screen to enable or disable a port on the managed AP and configure the port’s PVID.
To access this screen, select a port and click the Edit button in the Port Setting table of the Monitor >
Wireless > AP Information > AP List > Edit AP List or Configuration > Wireless > AP Management > Mgmt.
AP List > Edit AP List screen.
Figure 55 Monitor > Wireless > AP Information > AP List > Edit AP List > Edit Port
Each field is described in the following table.
6.11.2.3 VLAN Add/Edit
Use this screen to create a new VLAN or configure an existing VLAN on the NXC.
To access this screen, click Add or select a VLAN and click the Edit button in the VLAN Configuration
table of the Monitor > Wireless > AP Information > AP List > Edit AP List or Configuration > Wireless > AP
Management > Mgmt. AP List > Edit AP List screen.
Table 41 Monitor > Wireless > AP Information > AP List > > Edit AP List > Edit Port
LABEL DESCRIPTION
General Settings
Enable Select this option to activate the port. Otherwise, cancel the selection.
Port Properties
Name This shows the name of the port.
Native VID (PVID) A PVID (Port VLAN ID) is a tag that adds to incoming untagged frames received on a port
so that the frames are forwarded to the VLAN group that the tag defines.
Enter the PVID from 1 to 4094 for this port.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to close the window with changes unsaved.
To Next Page
Loading...
